jaymz_eric
Member
Join date : 2012-10-16
Points : 4296
Posts : 51
 |  Subject: Custom exhaust on Briggs I/C 16.5hp  January 14th 2013, 9:36 pm | |
| hey what kind of pipe and what diameter is used to make a exhuast stack on a briggs I/C 16.5hp single cylinder??? thanks guys! | |
|
Doug
Site Owner
2014 Build-Off Entrant
2014 Build-Off Entrant
2017 Build-Off Entrant
2017 Build-Off Entrant
Age : 28
Join date : 2012-12-24
Points : 7553
Posts : 3035
Location : Lebanon County, PA
| | Subject: Re: Custom exhaust on Briggs I/C 16.5hp January 14th 2013, 11:08 pm | |
| For pipe, you can use anything as long as its not plastic.
You will need to find the diameter yourself. To do that, you can look up parts for your model number, or take a tape measure (or analog/ digital caliper for better results) to find the inside diameter of the hole. I believe threading is fairly universal for exhaust.
If it a flange exhaust system, its a matter of either finding a flange that will fit your model or making one from scratch.  Head Forum Administrator ** Chat Moderator ** Facebook Page AdminATLTF Facebook Page ** Chatbox ** How To Upload Pictures
_X_ FORUM ANNOUNCEMENTS _X_Have a question? Ask me! Type in "@Doug" in your post!
Your ATLTF Staff:
Administrators: @Doug, @MightyRaze, @"Doc Sprocket", @Stretch44875
Moderators: @TheRainbowBoxer, @AllisKidD21, @Brianator, @RichieRichOverdrive
| |
|
CornShuck4CE
Member
Age : 35
Join date : 2014-04-07
Points : 4020
Posts : 337
Location : Woodville Al
| | Subject: Re: Custom exhaust on Briggs I/C 16.5hp April 8th 2014, 7:45 am | |
| I used 1 inch steel hydraulic tubing. My brother ownes a hydralic store so i used his tube bender and made a custome exaust. Runs down under right foot board and turns out in front of the rear tire. If its an OHV motor its not threaded so you will have to make a flange or cut the old one off and weld it on. I used a 4 doller screw in muffler from TSC to quietner down some. | |
|
Sponsored content
| |
