What engine can I use to RE-Power my offroader?

Subject: What engine can I use to RE-Power my offroader? July 20th 2013, 3:42 am

I like the 19.5hp briggs twin engines and was wondering if one would mount up to the tractor in my video?

Guest

Assuming those holes are the standard spacing (cant remember off the top of my head) then yes it will fit.

If the holes do not line up, you should still be able to pull it off with careful measurements. If you can get the engine positioned so that the shaft ends up in the original location, you would just have to drill new mounting holes. If not, you may have to mess with belt sizes.

***Get YOUR official "Doc Locked, And Ready To Rock!" Stickers by clicking here!***
***Official Sprocket's Garage vinyl graphics and tees for sale HERE!***

What engine can I use to RE-Power my offroader? Facebo12

Put down the wrench, and come out with your hands up!-Doc "Tranny Crusher" Sprocket, ATLTF Forum Admin, Thinkerer and Tinkerer, and all-around good dood. Wink

Gen. Mayhem- https://www.atltf.com/t2597-general-mayhem-race-tractor
MULE- https://www.atltf.com/t2153-lawn-boy-utltv
MULEII- https://www.atltf.com/t3328-1970-john-deere-112-the-beginnings-of-mule-ii
MULEIII https://www.atltf.com/t4263-mule3-brainstorming-ideas-etc#58287
Wrench, Wheel, Wreck, Repeat...

you can put anything you want on it.. its just a matter of measuring and fabricating. make sure the output pully is centered as the old one was, and you'll be set. if it dont line up, fab up some motor mounts. having to center everything will be a PITA, but can be done

» bbuckler's Rear Engine Offroader [2017 Build-Off Entry]
» Is a tecumseh formula engine big enough for a rear engine Murray law tractor?
» Honda HT-R 3009 mid engine rider engine swap
» mtd offroader
» Craftsman Offroader