So I’ve been doing a lot of dirt leveling recently and my inventive brain got to thinking. I have some steel scraps left over from the dump loader I am building, and my thought was to build an accompanying blade for smoothing out deposited loads. The problem is that due to clearance constraints I can only build it at about 6 inches or so in final height after the blade is bent. Is this adequate?
If anybody has any pictures I’d really like to see them. Thanks all!
Last edited by Rustbucket Garage on June 24th 2021, 4:56 pm; edited 1 time in total
AllisKidD21 Moderator
5000+ Posts
5000+ Posts!
2020 Build-Off Entrant
2020 Build-Off Entrant
1st Place Build-Off 2019
1st Place Build-Off Winner 2019
Age : 25 Join date : 2016-07-10 Points : 8380 Posts : 5190 Location : Ontario Canada
Subject: 
June 19th 2021, 8:14 pm
